If the vinyl does not separate from the liner simply burnish the transfer tape onto the vinyl and peel away again.
Which side is the liner on cricut vinyl.
Peel away the vinyl liner at a 45 degree angle.
Whatever mat and machine you are using put your adhesive vinyl paper backing side down onto your mat so the colored vinyl side is facing up see image below.
Select images and size and load the mat into the machine.
So in the above case you d want to put that iron on vinyl shiny side down on your cutting mat to cut out your mirrored design.
It s usually the shiniest side and you use a very sticky mat.
Use a craft stick or scraper found in the cricut tool kit to burnish rub or polish the tape onto the vinyl.
I don t know which side is the liner.
Here s the two sides of cricut everyday iron on vinyl here is the carrier side of the iron on vinyl which you can see is shiny.
Cutting vinyl with a cricut machine.
Refer to kiss cut guide below to adjust machine settings.
Sometimes that sheet has a grid on it to make it easy to cut straight.
It does say to mirror the image.
Cut on iron on vinyl setting.
Then position it plastic side down and vinyl side up the more dull less shiny side.
Place the iron on vinyl on the cricut standard grip cutting mat liner side down.
Cricut vinyl instructions say place material liner side down on to mat.
You can see the vinyl side up in this photo of heat transfer vinyl on a standard grip cutting mat.
If you look carefully at iron on vinyl there is a liner side and a vinyl side.
And here is the vinyl side which you can see is matte not shiny.
Iron on vinyl has a shiny side and a dull side.
You can tell iron on vinyl from regular vinyl by the front liner.
How to use adhesive vinyl with a cricut.
If you get nothing on the page then you know that is not printable side and that is the side that goes down on the mat.
Preparation with cricut transfer tape.
Generally adhesive vinyl has the colorful vinyl on one side and is backed by a paper carrier sheet that is most often white.
Peel back the sticky transfer tape from the liner sheet.
There is a very high gloss side and a dull matte side with the glitter in between.
It s the shinny side.
The cricut cutting mats are really similar and i have used cricut mats with my silhouette.
To prevent bubbles start in the center and move out toward the edges.
If your vinyl came on a roll you can cut off a piece to fit on your mat.
Can someone please tell me if its the shiny clear or the dull side that should be facing the mat.
The shiny side is the liner and the dull side is the heat activated side that you will adhere to an object.
The liner side should be the one placed down on the mat.
There is a layer of plastic that will be peeled away.
So again that s shiny side down.
Press flashing go button.
Remove the negative pieces from each of the images leaving the clear.
