Turn the dial counter clockwise one click left clockwise three clicks right counter clockwise one click left then clockwise one click right.
Whirlpool cabrio washer lid lock won t unlock.
Hold down the control lock button on your whirlpool washer for three seconds at the end of the washing cycle.
Step 3 if your whirlpool washer did not unlock at the end of step 1 press and hold the end of cycle button for five seconds to manually reset your washing machine.
Troubleshooting a whirlpool front loading machine.
Let the washer sit unplugged for about 10 minutes then try lifting the lid.
Listen and when you hear the unlatching sound the door should open.
This means the washer is unable to drain properly thus it won t unlock the door.
How to reset whirlpool cabrio washer.
Step 4 put the lid back down and plug the washing machine back into the electrical outlet.
The lid lock mechanisms on some washers are heat activated which means overriding them is as simple as letting them cool off.
Hello i m larry and thank you for using this service.
To diagnose this problem you ll want to put the washer in a spin mode.
Lid will not if door does not unlock check the lid lock motor winding and switches by removing p12 from the machine.
I ll be helping you with your problem today.
If not then the top panel just needs to be removed and the latch assembly replaced or if it s full of water it won t unlock either.
The lid can become locked if something is clogging the pump or filter drain.
Set the mode selector dial to normal.
Look for the lid lock switch on the underside of the top panel and where it fits into the appliance.
Read on to learn more about the.
If it still won t budge proceed to plan b.
Whirlpool cabrio washer wtw7340xu.
Stick a screw driver or putty knife under the front near the corners press the release tabs and raise the top and then you can unlock the lid ask your own appliance question.
If it opens you re all set.
If you have a washer that has a door or a lid that won t open a broken part like the door lock could be the source of the problem.
If your whirlpool cabrio washer will fill with water but won t spin the lid lock switch is probably bad.
Turn the washer off.
You ll need to tip the the washer backwards and unplug the unit so you can get under the washer.
Next open the lid and insert a screwdriver into the lid switch actuator hole.
This is one of the most common problems with direct drive washing machines.
